Bikesrepublic

Latest News

  • Here are our 10 Tips for Riding in the Rain.

  • Riding in the rain can actually be fun.

  • Train yourself right and you will never have to fear rain again.

We had published “How to Ride Through Flash Floods” some time back, so it’s only right that we present these 10 tips for riding in the rain since it’s the wet season in Malaysia. Oh wait… It’s either hot or raining, anyway.

Riding in the rain can be more fun since the weather is cooler. Your senses are also heightened for extra concentration.

1. Ride bright

To us, this is the primary requisite. If it’s already important to ride in bright clothing when it’s sunny, it becomes imperative in the rain. Do get yourself a set of waterproof gear in bright fluorescent yellow or fluorescent orange. Failing which, you can also wear a vest over your gear. Be seen, be safe.

2. Stop in safe areas

We’re bikers too, so we understand that we’ve to stop somewhere to pull on our rain gear or if conditions get too dicey to continue. However, use utmost discretion in where you choose to stop. Stopping under a flyover is an obvious opportunity, we won’t debate it, but don’t stay on your bike. Park it, switch on the parking lights (if so equipped) and go behind the barrier. There’ve been too many cases of zombie drivers who rammed into groups of motorcyclists under the flyover.

4. Slow down… but not too slow

Don’t slow down too much – Photo credit cycleworld.com

Slowing down in the rain is obvious, but don’t go too slow. The tyres need some speed to evacuate water from their contact patches. Besides that, the wheels need some speed to have gyroscopic forces which contribute to motorcycle stability. Riding too slow will cause the tyres to slide too early or loss of stability. There’s no hard rule to slow down by how much because it depends on the bike, tyres and rider. Going too slow is also dangerous because you may become a bowling pin for impatient/zombie/blind vehicle drivers. So, judge for yourself.

4. Be smooth

Being smooth at the controls allows the bike i.e. chassis, tyres to work like they’re intended to. Smooth here means no sudden changes in direction, acceleration and braking. As such, give yourself more room to the vehicles in front and all around you.

5. Stay loose

Photo credit ultimatemotorcycling.com

Stay loose on the bike by not stiffening up your body. Stiffening up runs counter to bike dynamics and it will force bad situations to become worse, for example if the tyres let go. Keep your arms and torso relaxed and clamp your thighs to the fuel tank at all times.

6. One thing at a time

Courtesy of Sport Rider

It means separating your braking, turning and acceleration inputs. It’s best to not brake and downshift at the same time, even if your bike is equipped with a slipper clutch. So do brake and downshift earlier before the corner, to allow the chassis and tyres to settle down before turning in. Also roll on your throttle smoothly through the corner and at the exit.

7. Puddles are NOT fun

Photo credit directasia.com

Yes, we loved to jump into puddles when we were kids. Or causing a huge splash when riding. But they can be downright dangerous as it’s hard to gauge the water’s depth or if it’s hiding a deep hole. So, steer clear if possible, but if you can’t, slow down and maintain a steady speed. Chopping the gas will have the water acting as an instant brake and can cause you to drop the bike.

8. Have a vision

The most difficult thing while riding in the rain is trying to see out of the helmet, right? Jet-type helmets (open-faced with visor) work best. On the other hand, if you ride with a full-faced helmet, get one with a Pinlock anti-fog insert. It makes all the difference in the world! However, please remember this: DO NOT flip up the visor as long as you’re under the rain, because if you do, rainwater will run down between the Pinlock and visor, causing it to fog.

Also, you can treat the outer part of the visor with light automotive wax. It will bead up the water into small droplets and the wind blows them away when you’re riding. It’s not perfect, but it sure beats a non-coated visor. Our favourite is the original Rain-X Plastic Water Repellant. (The important distinction here is “plastic.” DO NOT apply the normal Rain-X for car windshields on your helmet visor as the RainX will eat away its coating!)

9. The gloves stay on

Yes, they’ll get soaked, but twisting the throttle and holding on to the handlebar with bare palms is much less than fun. At least you’ve a better grip and your hands are kept protected by debris or (touch wood) a crash. Or have a spare pair of waterproof gloves. You can use the palms of the gloves to wipe your helmet visor, as a bonus. (This writer wears rubber surgical gloves under his regular gloves during rainy weather. A perk of having a wife who’s a nurse. Heh heh heh.)

10. Waterproof everything

Ziploc bags, a waterproof pouch, or even better a top case to carry your belongings. No one enjoys trying to dry soaked cash or other important stuff you may have in your wallet. Worse is your smartphone unless if it’s waterproof.

The folks from Kawasaki just posted a very interesting video showing the evolution of the extremely iconic Kawasaki Ninja GPZ900R. It’s basically a morphing video showing all 16 models of the GPZ900R since its launch back in 1984 all the way up to the last one released back in 2003. The question that keeps playing in our minds is, why would Kawasaki post up this video just last week? (more…)

We once wrote about the possibility of 2019 BMW S 1000 RR owners turning their superbikes into carbon fibre editions thanks to Ilmberger Carbon. Now, owners of the powerful Ducati Panigale V4 R can also turn their machines into carbon monsters with some very cool parts available for purchase on their website. (more…)

The Suzuki Katana has had quite a cult following ever since its birth ever since its release in the 1980s and the latest 2019 reincarnation model is nothing short of a crowd favourite from several markets around the globe. News about a ‘baby’ Katana model have been popping up and we might just see the appearance of the Suzuki Katana 125R sooner than we think. (more…)

FSR Technology is renowned for their electronics mastery in producing high-end performance ECUs at affordable prices for a selection of popular small-capacity motorcycles here in Malaysia. Earlier today, they’ve successfully launched their latest TuneBoss ECU for the Yamaha YZF-R15 V3 at their TuneBoss Owners Trackday at Sepang International Circuit. (more…)

  • Euro 5 emission standard begins in 2020.

  • But what are emissions?

  • How do they impact our daily lives?

This article should’ve been published some time back, but there’s still time since the Euro 5 emission standard takes effect from 2020. Surely, you’ve seen the “Euro 5” term in reviews and new model launches.

What are “emissions”?

An internal combustion engine turns fuel to energy which turns the wheels. But the burning of fuel releases by-products, but the six most polluting ones are:

  • Carbon dioxide,
  • Carbon monoxide,
  • Sulfur dioxide,
  • Nitrogen oxides,
  • Lead,
  • Particulate matter,
  • Hydrocarbons.

Carbon Dioxide (CO2)

CO2 is the primary product when the carbon in fuel isn’t combusted completely, since carbon is 60% to 90% part of fuel (petroleum is hydrocarbon). Internal combustion vehicles contribute the largest amount of CO2.

CO2 has long been proven as a greenhouse gas, which traps infrared radiation escaping from the surface of the earth and causes the atmosphere to heat up. In other words, it makes the world hotter and hotter. Such phenomenon is demonstrated on our planetary neighbour Venus. Its atmosphere is so hot it can melt lead (lead’s melting point is at 327.5 degrees Celsius).

Atmosphere heating leads to climate change as in mega droughts in one location, abnormal rainfall in another. The ice caps will eventually melt, causing worldwide megafloods. No, we didn’t get that from disaster movies, but from documentaries.

Carbon Monoxide (CO)

CO is colourless, odourless and tasteless gas, unlike in movies.

Although CO is not common is large quantities in ambient air, it can be poisonous even to healthy individuals. Prolonged exposure or exposure to elevated levels can lead to:

  • Visual impairment,
  • Reduced work capacity,
  • Reduced manual dexterity (muscular, skeletal and neurological functions to produce small and precise movements, like using the fingers to grab your motorcycle keys).
  • Poor learning ability,
  • Difficulty in performing complex tasks,
  • Individuals with cardiovascular disease may get angina pectoris (severe chest pain leading to shoulders, arms, neck).

You see, our blood cells called Hemoglobin (no, not the antagonist in Spider-Man) is an iron compound which carried oxygen (O2) from the lungs to tissues. It then transports CO2 back to the lungs to be expelled. Hemoglobin has a 240 time more affinity (attraction to) CO than to oxygen. As our total Hemoglobin is finite, the amount available to transport oxygen is reduced.

In worst cases, CO leads to death. Exposure to CO in enclosed spaces will first lead to drowsiness, fainting and death. The victim’s skin will turn flush red.

Sulfur dioxide (SO2)

SO2 is part of the family of sulfur oxide gases (SOx). The kicker is these gases dissolve easily in water and form acids. Sulfur is prevalent in all raw materials including crude petroleum, coal and metal ores such as aluminium, copper, zinc, lead, iron.

So, combustion of fuel produces SOx gases. These gases mixes with water vapour, other gases and particles in the atmosphere to become sulfates. Know the term acid rain? This is how it’s made.

Short-term exposure leads to breathing problems or asthma, while those with asthma may have breathing difficulties. Long-term exposure leads to aggravation of cardiovascular disease, respiratory illness and alternations to the lungs’ defences.

Nitrogren Oxides (NOx)

NOx is the general term for a group of highly reactive gasses that contain nitrogen and oxygen in varying amounts. Many among them are colourless and odourless. The form when fuel is burned at high temperatures, as in the combustion process. In fact, NOx is the largest form of emissions from combustion (up to 90%).

The most common form known nitrogen dioxide can be seen above our cities on certain days as that reddish-brown layer, which is also called smog. It’s the product of NO2 mixing with ground-level ozone and particles in the air.

It gets worse that blocking out a clear blue sky.

Short-term exposures (less than 30 hours) may lead to changes in airway responsiveness and lung function in those with pre-existing respiratory illnesses. It may also increase respiratory illnesses in children.

Long-term exposures to NO2 may lead to increased susceptibility to respiratory infection and may cause irreversible alterations in lung structure.

It destroys the environment, too. NOx is also a precursor to acid rain and ozone.

Increased nitrogen introduction to land and wetland ecosystems can lead to changes in plant species composition and diversity. Direct input to aquatic ecosystems leads to excessive algae growth which depletes dissolved oxygen and increases toxins harmful to aquatic life.

Particulate Matter (PM)

General term for mixture of solid particles and liquid droplets found in the air. Some are large enough to be seen as dust or dirt. Others are only detectable with an electron microscope.

There are two sources of PM:

  • “Primary” particles are formed through combustion process and emitted directly into the atmosphere. Examples include black carbon (soot) and dust from roads.
  • “Secondary” particles are formed in the atmosphere from primary emissions. An example is carbon soot from automobiles.

Particles smaller than or equal to 10 µm (micro metre or millionth of a metre) can be ingested into the lungs and cause health problems. They aggravate respiratory conditions such as asthma and bronchitis, and have long been associated with irregular heartbeats and heart attacks. Short-term exposures can also be associated with health problems.

Conclusion

These are just the basics! It’s so easy to forget about how polluting it is when we twist that throttle. But that’s what emissions standards are for: They’re there to specify lower emissions for the betterment of our planet and lives.

These emissions standards give rise to emissions control components such as the catalytic converter. So, you might want to think twice before you “de-cat” your bike or car.

That’s it for now, we’ll see what Euro 5 stipulates and how it impacts the motorcycle manufacturers and consumers.

Archive

Follow us on Facebook

Follow us on YouTube